Adaptec SBC-599 - Manual (Page 47)

Chapter 3 Software Configuration 37
Ethernet software configuration
(SBC-599 only)
The SBC-599 on-board Ethernet interface supports all major
network operating systems. To configure the medium type, to view
the current configuration, or to run diagnostics, do the following:
1. Power the SBC-599 on. Ensure that the RSET8029.EXE file
is located in the working drive.
2. At the prompt type RSET8029.EXE and press . The
Ethernet configuration program will then be displayed.
3. This simple screen shows all the available options for the
Ethernet interface. Just highlight the option you wish to change
by using the Up and Down keys. To change a selected item,
press , and a screen will appear with the available
options. Highlight your option and press . Each
highlighted option has a helpful message guide displayed at
the bottom of the screen for additional information.
4. After you have made your selections and are sure this is the
configuration you want, press ESC. A prompt will appear
asking if you want to save the configuration. Press Y if you
want to save.
The Ethernet Setup Menu also offers three very useful diagnostic
functions. These are:
1. Run EEPROM test
2. Run Diagnostics on Board
3. Run Diagnostics on Network
Each option has its own display screen that shows the format and
result of any diagnostic tests undertaken.