Adaptec SBC-599 - Manual (Page 69)

Chapter 5 PCI SVGA Setup (SBC-599 only) 59
OS/2 Drivers Setup Procedure
Preliminary Steps
The following steps must be performed before you install the
65550/554 display driver:
1. OS/2 DOS Support must be installed.
2. If you previously installed SVGA support, you must reset the
system to VGA mode. VGA is the default video mode enabled
when OS/2 is installed.
To restore VGA mode, use Selective Install and select VGA for
Primary Display. For more information on this procedure, see the
section on Changing Display Adapter Support in the OS/2 User’s
Guide.
Installing from Diskette
To install this driver, do the following steps:
1. Open an OS/2 full screen or windowed session.
2. Place the Supporting CD-ROM into your CD-ROM drive.
3. At the OS/2 command prompt, type the following commands
to copy the files to the OS/2 drive:
Type:
CD-ROM drive: \CD ROM\"model name"\driver\vga
driver\OS2\
"model name": the model number of your product
When the Setup Program is completed, you will need to perform a
shutdown and then restart the system in order for changes to take
effect.