Spektrum SPM18100 DX18 - Manual (Page 8)

8 SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL
EN
• Turn the scroll wheel to move through the screen content or
change programming values. Press the scroll wheel to make
a selection.
• Use the Back button to go to the previous screen
(for example, to go from the Mixing Screen to the Function
List).
• Use the Clear button to return a selected value on a screen to
the default setting.
• Direct Model Access enables you to access the Model Select
screen without powering off the transmitter. Anytime the
transmitter power is on, press the Clear and Back buttons to
access the Model Select screen.
• Press and hold the roller while powering on the transmitter
to show the System Setup list. No radio transmission occurs
when a System Setup screen is displayed, preventing
accidental damage to linkages and servos during changes to
programming.
• At the main screen you can roll the roller to view the servo
monitor.
• The Main Screen appears when you power on the transmitter.
Press the scroll wheel once to display the Function List.
• When you want to change a value in a screen for a particular
control position, move the control to the desired position to
highlight the value you want to change, such as 0/1/2, up/
down or left/right.
Enter, Choose
or Exit Move between
options or change
value in an option Hold for 3
seconds and
release to move to
the Main Screen
Turn Hold Press
Tip: The tick mark below shows the current switch position.
Rolling and clicking the roller turns the selected box black,
indicating that the value or condition will act on that position.
Navigation
Main Screen
Volume Control
Volume control is adjusted from the Main Screen.
To change the volume:
1. Press the BACK button.
2. Turn the scroll wheel left or right to adjust the volume level.
3. Press the scroll wheel to save the selection.
Function
A Model Name
DSMX ® /DSM2 ® If not shown, this indicates “not bound”
C
Transmitter Battery
Charge Level
D
Digital Battery Voltage (an alarm sounds and the screen
fl ashes when battery charge gets down to 4.3V when us-
ing an NiMH battery or 6.4V for a LiPo/Li Ion battery.)
E Model Type
F
Elevator Trim
(Modes 2 and 4)
Throttle Trim
(Modes 1 and 3)
G
Aileron Trim (Modes 1 and 2)
Rudder Trim (Modes 3 and 4)
H Model Memory Timer
Function
I
Rudder Trim (Modes 1 and 2)
Aileron Trim (Modes 3 and 4)
J
Throttle Trim (Mode 2 and 4)
Elevator Trim (Mode 1 and 3)
K Timer
L Active Flight Mode
Also displays L Trim values when
the Left Trim button is pressed
E
D
C B
J
K
A
F
G I H
Also displays the Volume Level
when the BACK button is pressed
B
L
Also displays R Trim values when
the Right Trim button is pressed