Swiftech H20 8500 User Manual

Page 8

Rouchon Industries, Inc., dbA Swiftech – 1703 E. 28

St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content

- 8 -

Clean off the opening of the fittings to prevent the last remnants of
moisture to drop into your case.

For absolute safety, it is good practice to let the cooling
system run overnight before you fire-up your computer!

WARNING: DO NOT ATTEMPT TO LEAK-TEST THE CIRCUIT USING
COMPRESSED AIR OR CITY WATER PRESSURE. THIS WILL CAUSE
EXCESSIVE INTERNAL PRESSURE INSIDE THE PUMP, RESULTING IN
IMMEDIATE AND IRREVERSIBLE DAMAGE TO THE PUMP, AND VOID
YOUR WARRANTY. LEAK-TESTING CAN ONLY BE PERFORMED BY
RUNNING THE PUMP ITSELF AND/OR GRAVITY FEEDING THE
CIRCUIT. EXCESSIVE INTERNAL PRESSURE CAN ALSO BUILT-UP
WHEN USING THERMO-ELECTRIC DEVICES WITHOUT APPROPRIATE
COOLING TO THE DEVICE, AND IS NOT COVERED BY OUR
WARRANTY.

Now that your system is filled and bled, complete the installation of the processor (and graphics card if applicable): remove the tape you
used to protect the processor(s), clean off the surface of the core(s) with rubbing alcohol to remove any possible residues of glue
transferred from the masking tape, coat the cores with the provided thermal compound, following instructions described in the individual
installation guides provided with your water-block(s).

REMEMBER to reconnect the L wire from the A/C socket to the N\O position on the relay switch !!!

REMEMBER to connect the 4-pin Molex connector from switch to the computer power supply once it has been installed.

IMPORTANT DISCLOSURE

While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech assumes no liability expressed or implied for
any damage(s) occurring to your components as a result of using Swiftech cooling products, either due to mistake or omission on our part in
the above instructions, or due to failure or defect in the Swiftech cooling products.

WARRANTY

Our products are guaranteed for 12 months from the date of delivery to the final user against defects in materials or workmanship. Pump is
guaranteed for 24 months. During this period, they will be repaired or have parts replaced provided that: (I) the product is returned to the
agent from which it was purchased; (II) the product has been purchased by the end user and not used for hire purposes; (III) the product has
not been misused (*), handled carelessly, or other than in accordance with any instructions provided with respect to its use.

This guarantee does not confer rights other than those expressly set out above and does not cover any claims for consequential loss or
damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as a consumer.

For service, support, or questions, please contact:

Swiftech - 1703 E. 28

St., - Signal Hill, CA 90806 - T. (562) 595-8009 - F. (562) 595-8769 –

E-mail:

[email protected]

- URL:

http://www.swiftnets.com

(*) WARNING: DO NOT ATTEMPT TO LEAK-TEST THE CIRCUIT USING COMPRESSED AIR OR CITY WATER PRESSURE. THIS WILL CAUSE
EXCESSIVE INTERNAL PRESSURE INSIDE THE PUMP, RESULTING IN IMMEDIATE AND IRREVERSIBLE DAMAGE TO THE PUMP, AND VOID YOUR
WARRANTY. LEAK-TESTING CAN ONLY BE PERFORMED BY RUNNING THE PUMP ITSELF AND/OR GRAVITY FEEDING THE CIRCUIT. EXCESSIVE
INTERNAL PRESSURE CAN ALSO BUILT-UP WHEN USING THERMO-ELECTRIC DEVICES WITHOUT APPROPRIATE COOLING TO THE DEVICE, AND
IS NOT COVERED BY OUR WARRANTY.

IMPORTANT PRECAUTION: ONCE YOUR SYSTEM IS COMPLETELY INSTALLED, AND YOU FIRE IT OFF FOR THE FIRST
TIME, ALWAYS TOUCH THE PUMP TO FEEL IT VIBRATING: THIS IS EVIDENCE THAT YOUR PUMP IS WORKING !