Attach the rack-mounting brackets to each side, Figure22 attaching rack-mounting brackets, Mount the unit in the rack – Allied Telesis AT-3726 User Manual
Page 23: Apply power to the unit as follows
AT-3714F and AT-3726 Installation Guide
2-5
3. Attach the rack-mounting brackets to each side of the switch, using
the 6 flathead screws provided.
Figure 2-2 Attaching Rack-Mounting Brackets
4. Mount the unit in the rack.
5. Apply power to the unit as follows:
Caution
Power cord is used as a disconnection device. To de-energise equip-
ment disconnect the power cord.
Attach the power cord to the unit and plug it in the wall outlet.
Verify that the PWR LED lights green. See Table 2-1, LEDs
OR PORT
RS-232
TERMINAL
PORT
STATUS
RESET
K
FAUL
T
POWER
This manual is related to the following products: