Allied Telesis AT-MC602 - Manual (Page 50)

Troubleshooting
50
❑ “ P side must be connected to start this procedure” or “S side
must be connected to start this procedure ”
These error messages occur when the management cable is
connected to the wrong unit for the procedure you are trying to
perform.This could happen if you switch the management cable
between the units without closing the software window. Simply
switch the management cable to the other unit to correct the
problem.
❑ “ Can't read link status ”
This message occurs when the software cannot read the link
status from the Provider side. Perform the procedure described in
”Configuring the Subscriber Unit” on page 45 to see if link
recovery on the Subscriber unit solves the problem.
❑ “ Please run this program on S side to set it in Install mode. If S
side is already in install mode then configuration can not be
achieved,”
as shown in Figure 29.
Figure 29 Run on S Side Error Message
This error message occurs when the Provider unit cannot achieve
the link with the S or Subscriber side unit using the default speeds
value. Set the Subscriber to Install Mode, as described in
”Configuring the Subscriber Unit” on page 45.
❑ “ Configuration file was not found ”
❑ “ Syntax error in configuration file ”
❑ “ Configuration cannot be achieved ”
These last three error messages indicate a problem with the
configuration software. Try re-loading the software onto your
computer.