Allied Telesis AT-MC602 - Manual (Page 30)

Installation
30
Installing the AT-MC602 Provider Unit
The AT-MC602 Provider unit can only be installed in an AT-MCR12
rackmount chassis.
Warning
To prevent exposure to electric shock, the AT-MC602 Provider Unit
must be installed in a RESTRICTED ACCESS LOCATION and
performed by QUALIFIED SERVICE PERSONNEL.
Note
For Finland, Norway, and Sweden – When the AT-MC602 and the
AT-MCR12 are used, a permanent ground conductor must be
installed on the AT-MCR12 chassis.
For installation instructions of this ground conductor, refer to the
AT-MCR12 Media Converter Rackmount Chassis Installation Manual
(PN 613-10725-00).
To install the Provider unit in an AT-MCR12 rackmount chassis, perform
the following steps:
1. Attach the unit to one of the sliders that will hold the unit in the
chassis, as shown in Figure 13.
Figure 13 Rack Mount - Set on Slider
LINE
10Base
T /
100Base
T X
PSTN
LINK ACT PWR
ERR LINK
MGMT
A T -MC601
VDSL EXTENDED ETHERNET