Allied Telesis AT-MC602 - Manual (Page 37)

AT-MC601, AT-MC602 Installation and User’s Guide (For Use with AT-MCR12 Only)
37
Opening the
Configuration
Software
Open the configuration software by double-clicking the “ATS57”
application icon, as you would with any other software program. The AT-
MC60x Configurator pop-up will appear, as shown in Figure 19.
Figure 19 AT-MC60x Configurator
If you would like to verify that you are using the latest version of the
configuration and management software, click the About button on the
bottom right of the AT-MC60x Configurator pop-up. The About AT-
MC60x Configurator pop-up will appear, as shown in Figure 20.
Figure 20 About AT-MC60x Configurator
Select the computer port you are using from the pull-down menu on the
AT-MC60x Configurator pop-up and click OK.
If you are connected to the AT-MC602 Provider unit and want to
configure the network extenders, continue with the next section,
”Configuring the Provider Unit” on page 38. If you are connected to the
AT-MC601 Subscriber unit to attempt link recovery, continue with
”Configuring the Subscriber Unit” on page 45.