Allied Telesis AT-MC602 - Manual (Page 38)

Configuration
38
Configuring the Provider Unit
After performing the procedure described in the previous section,
”Starting a Configuration Session” on page 36, if you are connected to
the Provider unit, the AT-MC60x Configurator menu will appear. The
Configurator bar at the top of the menu indicates whether or not the
Provider unit has established an Ethernet link by displaying [link DOWN]
or [link UP] in brackets.
The AT-MC60x Configurator menu has three screens: Configuration,
VDSL Status, and Ethernet Status. The parameters on these screens are
described below. Use the tabs at the top of the menu to toggle between
these screens. When you have finished viewing or adjusting the
parameters on the menu screens, click the Close button on the bottom
right of the menu to exit from the configuration software.
Configuration The Configuration screen displayed in Figure 21 is shown first by default.
Figure 21 Configuration