Allied Telesis AT-S79 - Manual (Page 59)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 59
Creating a Port Trunk
This procedure explains how to create a port trunk.
Caution
Do not connect the cables to the ports on the switches until after you
have configured the trunk with the management software.
Connecting the cables before configuring the software creates a
loop in your network topology, which can result in broadcast storms
and poor network performance.
To create a port trunk, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 14.
Figure 14. Advanced Switch Configuration Menu
2. From the Advanced Switch Configuration Menu, type T to select Trunk
Configuration.
AT-GS950/24 Local Management System
Main Menu -> Advanced Switch Configuration Menu
[V]LAN Management
[T]runk Configuration
Quality of [S]ervice Configuration
Port [M]irroring Configuration
802.x[X] Port Based Access Control Configuration
[Q]uit to previous menu
Command>