Allied Telesis AT-S79 - Manual (Page 121)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 121
Configuring the RADIUS Client
To configure the RADIUS client, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 30.
2. From the Basic Switch Configuration Menu, type U to select User
Interface Configuration.
The User Interface Configuration Menu is shown in Figure 7 on page
36.
3. Type R to select RADIUS Server Configuration.
The RADIUS Server Configuration Menu is shown in Figure 29.
Figure 29. RADIUS Server Configuration Menu
4. Type I to select Set Server IP.
The following prompt is displayed:
Enter IP address for RADIUS server>
5. Type the IP address of the RADIUS server and press Enter.
6. Type C to select Shared Secret.
The following prompt is displayed:
Enter secret string for server>
AT-GS950/16 Local Management System
Basic Switch Configuration -> RADIUS Server Configuration Menu
Server IP Address : 0.0.0.0
Shared Se[c]ret :
Response Time : 10 seconds
Maximum Retransmission : 3
----------------------- -----------------------------
Set Server [I]P
Set Shared Se[c]ret
Set [R]esponse Time
Set [M]ax Retransmission
[Q]uit to previous menu
Command>