Allied Telesis AT-S79 - Manual (Page 198)

Chapter 21: RADIUS Authentication Protocol
198 Section II: Using the Web Browser Interface
Configuring the RADIUS Client
To configure the RADIUS client, perform the following procedure:
1. From the Basic Config menu, select RADIUS Config.
The RADIUS Server Configuration Menu is shown in Figure 56.
Figure 56. RADIUS Configuration Menu
2. To enter the RADIUS server’s IP address, enter the address in the
Server IP Address field.
3. To specify the server’s encryption key, click the Shared Secret field
and enter the encryption key.
4. To change the response time setting, click the Response Time field
and enter a new value. The response time is the amount of time in
seconds the switch waits for a response from the RADIUS server. The
range is 1 to 120 seconds. The default is 10 seconds.
5. To change the maximum retransmissions setting, click the Maximum
Retransmissions and enter a new value. This parameter specifies the
number of times the switch should retransmit to the RADIUS in the
event the server does not respond. The range is 1 to 254. The default
is 3.
6. Click Apply to save your changes.