Allied Telesis AT-S95 WEB - Manual (Page 26)

Page 26
Allied Telesis
AT-S95 Management Software Web Browser Interface User’s Guide
Figure 9: IPv6 Interface Page
The IPv6 Interface Page contains the following fields:
• Interface — Indicates the interface on which the IPv6 interface is defined. The possible field values are:
– VLAN — Indicates the VLAN ID on which IPv6 is enabled.
– Tunnel1 — Indicates the IPv6 tunnel on which IPv6 is enabled.
• DAD Attempts — Defines the number of consecutive neighbor solicitation messages that are sent on an
interface while DAD is performed on Unicast IPv6 addresses on this interface. New addresses remain in a
tentative state while duplicate address detection is performed. The range is 0 - 600. A field value of 0,
disables duplicate address detection processing on the specified interface. A field value of 1 is the default.
The IPv6 Table on the IPv6 Interface Page displays the IPv6 addresses defined on the Interface. This table
contains the following fields:
• Delete Button — Deletes the selected IPv6 address. Entries that cannot be removed because they are
generated automatically by the system are unavailable. Only addresses configured by a user can be
removed. The possible field values are:
– Selected — Removes the selected IPv6 address.
– Cleared — Maintains the IPv6 address.
• IPv6 Type — Defines the type of configurable IPv6 IP address for the interface. The possible values are:
– Link Local — Defines a Link Local address; non routable and can be used for communication on the
same network only. A Link Local address has a prefix of 'FE80'.