Allied Telesis AT-S95 WEB - Manual (Page 236)

Page 236
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Figure 164:Stacking Page
The Stacking Page contains the following stack configuration fields:
• Force Master — The unit is forced to be master of the stack. Note that only Unit 1 or Unit 2 can be the stack
master. Select None for the system to decide which of the two master-enabled units is the master in the
stack.
• Unit No. — Indicates the Unit ID assigned to the unit in the current stacking configuration.
• Unit No. After Reset — Indicates the Unit ID to be reassigned to the unit in the stacking configuration after
reset.
2. Select the master election method, type of ports to be used in stacking,
3. Map/assign the unit numbers.
4. Click Apply. A confirmation message displays. The stacking settings are saved and the device configuration
is updated.
5. Click Refresh. The stacking configuration is applied.
6. Click Save Config on the menu to save the changes permanently.
If a different Unit ID is selected, the device must be reset for the configuration changes to be applied.