Allied Telesis AT-GS950/16 - Manual (Page 46)

Chapter 2: System Configuration
46
Note
See Chapter 16, “SNMPv1 and v2c” on page 209 and Chapter 17,
“SNMPv3” on page 223 to configure the remaining SNMP
parameters.
4. Click Apply under the Web Server Status field.
5. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
User Interface
Timeout
To set the Web Idle Timeout, perform the following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select User Interface.
The User Interface Page is displayed. See Figure 17 on page 45.
3. Refer to the bottom portion of the web page. Enter the Web Idle
Timeout parameter. The range is from 3 to 60 minutes.
4. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
Group Interval To set the SNMP Group Interval Timeout, perform the following
procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select User Interface.
The User Interface Page is displayed. See Figure 17 on page 45.
3. Refer to the bottom portion of the web page. Enter the Group Interval
parameter. The range is from 0 or 120 to 1225 seconds. 0 disables the
interval.
4. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.