Allied Telesis AT-GS950/16 - Manual (Page 152)

Chapter 12: Storm Control
152
Configuration
This procedure explains how to set DLF, broadcast, multicast, and
threshold levels for each port on the AT-GS950/16 switch.
To change the settings of the storm control feature, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
2. From the Bridge folder, select Bandwidth Control.
The Bandwidth Control folder expands.
3. From the Bandwidth Control folder, select Storm Control.
The AT-GS950/16 Storm Control page is displayed. See Figure 53 for
a partial view of this page.
Figure 53. AT-GS950/16 Storm Control Page
4. To enable or disable the DLF field, select Enable or Disable from the
DLF pull-down menu next to the port that you want to change.
You can select the All row to set all of the ports to the same setting.
The Ignore parameter indicates that the setting in the All row does not
apply to the DLF menu for individual ports. In other words, each port is
set individually.
Note
For more information about the Destination Lookup Failure (DLF)
setting, see “Overview” on page 150.
5. Click Apply.