Allied Telesis NetExtreme II Adapters - Manual (Page 83)

AT-2973SX, AT-2973T, AT-2973T/4, and AT-VNC10S Adapters Installation and User’s Guide
83
rpm -e open-iscsi
2. Install the source RPM package by entering:
rpm -ivh .src.rpm
3. CD to the RPM path and build the binary driver for your kernel. Enter:
cd /usr/src/{redhat,OpenLinux,turbo,packages,rpm
..}
rpm -bb SPECS/.spec
or
rpmbuild -bb SPECS/.spec
(for RPM version 4.x.x)
Note
The RPM path is different for each Linux distribution.
4. Install the newly built package by entering:
rpm -ivh RPMS//
name>..rpm
where is the machine architecture such as i386.
rpm -ivh RPMS/i386/
name>.i386.rpm
5. Start the daemon by entering:
iscsid
Binding iSCSI Target to Broadcom NX2 iSCSI Transport Name
By default, the open-iscsi daemon connects to discovered targets using
software initiator (transport name = 'tcp'). If you want to offload an iSCSI
connection onto CNIC device should explicitly change the transport
binding of the iSCSI node. This can be done using iscsiadm cli utility as
follows:
iscsiadm --mode node --targetname iqn.2004-
06.com.broadcom:tg1 \
--portal 192.168.1.100 --op=update \
--name=node.transport_name --
value=${XPORT_NAME}