Allied Telesis NetExtreme II Adapters - Manual (Page 62)

Chapter 5: Installing the NDIS2 Driver Software
62
5. Edit the Autoexec.bat file by adding the following lines:
C:\LANMAN\NETBIND.EXE

C:\LANMAN\NET START WORKSTATION

C:\LANMAN\NET USE drive letter : \\ server
name \ resource name
6. Edit the Protocol.ini file (located in C:\LANMAN) to configure the
driver to bind with NetBEUI or any other protocols.
Here is an example:
[PROTOCOL MANAGER]

DriverName = PROTMAN$ 
[NETBEUI_XIF]

DriverName = netbeui$

BINDINGS = BXND20X

[BXND20X] 
DriverName = "BXND20X$"
7. Restart the computer to complete the installation.
Note
The driver loads during system configuration and displays the
Broadcom banner, controller name, MAC address, IRQ number,
detected line speed, and the controller BusNum and DevNum. If the
driver fails to load, an initialization fail message is displayed. For
more information about the BusNum and DevNum keywords, see
“Using Keywords for the Drivers” on page 63.