Allied Telesis NetExtreme II Adapters - Manual (Page 61)

AT-2973SX, AT-2973T, AT-2973T/4, and AT-VNC10S Adapters Installation and User’s Guide
61
6. Create the appropriate Autoexec.bat file in drive A for the chosen
protocol as shown:
TCP/IP
Here is an example of the TCP/IP autoexec.bat file:
path=a:\net

a:\net\net initialize

a:\net\netbind.com 
a:\net\umb.com 
a:\net\tcptsr.exe

a:\net\tinyrfc.exe

a:\net\nmtsr.exe 
a:\net\emsbfr.exe

a:\net\net start basic

net use z: \\SERVERNAME\SHARENAME
NetBEUI
Here is an example of the NetBEUI autoexec.bat file:
SET PATH=A:\NET 
A:\NET\NET START BASIC
net use z: \\SERVERNAME\SHARENAME
7. Create a Config.sys file on the startup disk in drive A as shown:
files=30

device=a:\net\ifshlp.sys

lastdrive=z
Installing the
DOS NDIS2
Driver Software
To install the DOS NDIS2 Driver Software on the hard disk, do the
following:
1. Verify that the system has Microsoft LAN Manager 2.2 installed, with a
protocol such as NetBEUI configured.
2. Create a folder on your hard disk to store the NDIS 2.01 driver.
Example: C:\LANMAN
3. Copy the BXND20X.dos file to this folder.
4. Edit the Config.sys file by adding the following lines:
DEVICE = C:\LANMAN\PROTMAN.DOS 
DEVICE = C:\LANMAN\BXND20X.DOS

DEVICE = C:\LANMAN\NETBEUI.DOS