Allied Telesis AT-GS950/48 - Manual (Page 46)

Chapter 2: System Configuration
46
Note
The ATI Web Discovery Tool is available for download on the
AT-GS950/48 product page at alliedtelesis.com.
6. Follow the procedure to log on with the new IP address provided by
the DHCP Server as described in “Establishing a Remote Connection
to the Web Browser Interface” on page 20.
7. Save your new settings or any changes to the configuration file by
selecting Save Configuration to Flash from the main menu on the left
side of the page.
If you do not save the new configuration when DHCP is enabled, the
software reverts to the previously saved IP address value when the
switch is power cycled or rebooted. If no IP address has been
previously saved, the IP address value reverts to 192.168.1.1.
If you enable DHCP and then save your configuration, you are saving
the DHCP setting (Enabled). The next time the switch boots up, it will
use the DHCP process to establish the IP address used to manage the
AT-GS950/48 switch.
If you enter a new IP address after disabling DHCP and save your
configuration, the DHCP setting (Disabled) and the new IP address on
the switch is saved. The next time the switch boots up, it will respond
to the IP address that you entered when you re-establish contact with
the AT-S116 Version 1.0.0 Management software.