beautypg.com

Switch reboot – Allied Telesis AT-GS950/48 User Manual

Page 330

background image

Chapter 27: Rebooting the AT-GS950/48

330

Switch Reboot

The following procedure outlines how to reboot your AT-GS950/48 switch.

Caution
This procedure reboots the switch and reloads the AT-S116 Version
1.0.0 Management software configuration from flash memory.
Insure that your current configuration is saved before rebooting the
switch by selecting Save Configuration to Flash from the main
menu on the left side of the page to permanently save your changes.

All configuration parameters that have not been previously saved
are lost. After the switch is reboots, they are reset to the values
stored in the flash memory.

Caution
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.

1. From the main menu on the left side of the page, select the Tools

folder.
The Tools folder expands.

2. From the Tools folder, select Reboot.

The Factory Default Reset/Reboot Page is displayed. See Figure 132.

Figure 132. Factory Default Reset/Reboot Page

3. Go to the lower part of the page to the Reboot section.