Allied Telesis AT-GS950/48 - Manual (Page 142)

Chapter 12: Storm Control
142
Configuration
This procedure explains how to set DLF, broadcast, multicast, and
threshold levels for each port on the AT-GS950/48 switch.
To change the settings of the storm control feature, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
2. From the Bridge folder, select Storm Control.
The Storm Control folder expands.
3. From the Storm Control folder, select Storm Control.
The AT-GS950/48 Storm Control page is displayed. See Figure 46 for
a partial view of this page.
Figure 46. AT-GS950/48 Storm Control Page
4. To enable or disable the DLF field, select Enable or Disable from the
DLF pull-down menu next to the port that you want to change.
You can select the ALL row to set all of the ports to the same setting.
Note
For more information about the Destination Lookup Failure (DLF)
setting, see “Overview” on page 140.
5. Click Apply.
6. To enable or disable ingress and egress Broadcast packets, select
Enable or Disable from the Broadcast pull-down menu next to the
port that you want to change.
You can select the ALL row to set all of the ports to the same setting.