Samsung SPH-Z400DAASPR - Manual (Page 131)

114 Section 2I. Voice Services
Resetting Voice Recognition
1. Press Menu > Tools > Voice Service > Set
(left softkey) > Train Mode .
2. Select Reset Voice and press . (The phone
displays a reset dialog.)
3. Press OK (left softkey) to reset the voice recognition
parameters or Cancel to exit.
Using Choice Lists
If your phone is not confident it has recognized a name
or number correctly, it might display a choice list and
prompt you with “
Call? ” followed by the first choice on
the list. To confirm the choice, say “ Yes ,” or to hear the
next choice, say “ No .” You can also select the correct
choice using your keypad. To cancel the command,
say “
Cancel ,” or to say the name or number again, say
“ Repeat .”
Enabling and Disabling Choice Lists
You can customize whether the Voice Recognition
feature displays either a list of top voice recognition
choices or automatically dials the first number without
displaying a choice list.
To enable or disable choice lists for Digit Dial:
1. Press Menu > Tools > Voice Service > Set (left softkey)
> Choice Lists .
2. Select Automatic or Always Off and press .
Send a Message
Use a single voice command to launch messaging on
your phone and specify a recipient for the message.
To send a text message:
1. Press and hold .
2. Say “ Send Text Message .”
Note It is recommended that you perform the complete
Adapt Voice session at least once to achieve the
maximum benefit of this feature. If a partial
adaptation is performed, you can always return later
and resume the process from the halfway point.
Z400.book Page 114 Wednesday, September 3, 2008 3:26 PM