Samsung HT-H6500WM-ZA - Manual (Page 21)

21
- English
Settings
Ğ Wired~-~Manual
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network~Settings values manually.
After following Steps 1 to 3 above:
1.~ In the Network~Settings screen, change
Network~type to Wired. Then, select Connect
and press the Ok button.
The product searches for a network, and
then displays the connection failed message.
✎ If it is possible to connect the home theater
to your network wirelessly, select Change~
Network at this point, change the Network~
type to Wireless, and then go to the
instructions for wireless networks on this
page.
Network~Settings
Wired~network~connection~failed.
MAC~Address xx:xx:xx:xx:xx:xx
Ip~Address ~~~0.~~~0.~~~0.~~~0
Subnet~Mask ~~~0.~~~0.~~~0.~~~0
Gateway ~~~0.~~~0.~~~0.~~~0
dNS~Server ~~~0.~~~0.~~~0.~~~0
Unable~to~connect~to~the~network.~Try~the~following:~check~if~your~Ip~address~is~set~~
correctly~in~Ip~Settings.~Contact~your~Internet~Service~provider~for~more~information.
Change~Network Ip~Settings Retry Close
2.~ Use the buttons to select Ip~Settings,
and then press the Ok button. The Ip~Settings
screen appears.
3.~ Select the Ip~Setting field, and then set it to
Enter~manually.
4.~ Select a parameter to enter (Ip~Address, for
example), and then press Ok . Use the ,.
buttons on the remote control to enter the
numbers for the parameter. Or use the Num
keypad to enter a parameter number. Press and
hold the 123 button until the Num pad appears
on the screen. When the Num pad appears,
select a number using the ,.
button and
then press the Ok button. Use the
buttons on the remote control to move from
entry field to entry field within a parameter.
When done with one parameter, press the
Ok button.
5.~ Press the , or . button to move to another
parameter, and then enter the numbers for
that parameter following the instructions in
Step 4.
6.~ Repeat Steps 4 and 5 until you have filled in
all parameters.
✎ You can get the network parameter values
from your Internet provider.
7.~ When finished entering all the parameter
values, select Ok, and then press the Ok
button. The home theater verifies the
network connection and then connects to
the network.
Wireless~Network
You can set up a wireless network connection in
three ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
Before you configure the wireless network
connection, disconnect any wireless network
devices currently connected to the product
or, if applicable, the product's current wired
connection.
Ğ Wireless~-~Automatic
After following Steps 1 to 3 in "Configuring Your
Network Connection" on page 20:
1.~ In the Network~Settings screen, change
Network~type to Wireless. The product
searches for and then displays a list of the
available networks.
Network~Settings
Select~your~network~type.
Network~type~ Wireless
Wireless~network
si-ap
iptime
kIMING_vTOWER
you~can~connect~your~Blu-~
ray~player~to~the~internet.
please~select~which~wireless~~
network~to~use.
Refresh WpS(pBC)
2.~ Select the desired network, and then press
the Ok button.
3.~ On the Security screen, enter your network's
security code or pass phrase.
Enter letters by selecting a letter with ,.
buttons, and then pressing Ok button.
4.~ When finished, select done, and then press
the Ok button. The product verifies the
network connection and then connects to
the network.