Using a smart phone as a remote shutter release 5 – Samsung EV-NXF1ZZB1QUS User Manual
Page 132
131
Wireless network >
Using a smart phone as a remote shutter release
5
On the camera, allow the smart phone to connect to your
camera.
If the smart phone has been connected to your camera before, it is
connected automatically.
6
On the smart phone, select q to open the smart panel.
7
On the smart phone, set the shooting options.
While using this feature, some buttons are not available on your
camera.
With the smart phone, you can operate the camera only by
touching the screen.
Some shooting options are not supported.
Shooting options that you have set will remain on the camera after
the connection with the smart phone has ended.
8
Touch
to return to the shooting screen.
9
On the smart phone, touch and hold
to focus, and then
release it to capture the photo.
Touch to record a video and touch to stop a video.
If the GPS feature is activated on the smart phone, the GPS
information will be saved with the captured photo.
When you use this feature, the ideal distance between the camera and the
smart phone may vary, depending on your surroundings.
The smart phone must be within 7 m of the camera to use this feature.
It will take some time to capture the photo after you release
on the smart
phone.
If the file save option is set to Smartphone + Camera, only photos will be
transferred to the smart phone. (Videos and RAW files will not be transferred.)
If you capture photos continuously when the file save option is set to
Smartphone + Camera, photos will not be transferred to the smart phone.
The smart phone's screen will not mirror the camera's display when recording
a video.
The Remote Viewfinder function will deactivate when:
-
there is an incoming call on the smart phone
-
either the camera or the smart phone turns off
-
device loses its connection to the WLAN
-
the Wi-Fi connection is poor or unstable
-
you perform no operations for approximately 3 minutes while connected
-
folder and file number are max values
The screen turns off if you perform no operations on the camera for
30 seconds.