Samsung SC-D383-XAP - Manual (Page 66)

62_ English 臺灣 _62
在 LCD 螢幕上播放錄影帶
播放功能和喇叭僅可在 Player 模式下操作。 ➥ 第 18 頁
您可以在 LCD 螢幕上監視播放畫面。
1. 放入您要檢視的錄影帶。 ➥ 第 34 頁
2. 將選擇開關設定為
TAPE。（僅適用於 SC-D383/
D385）
3. 按下 MODE 按鈕以設定 Player ( ).
4. 打開 LCD 螢幕。
調整 LCD 螢幕的角度、如有必要、設定亮度或
色彩。 ➥ 第 31 頁
5. 按下 Joystick、然後向左或向左移動 Joystick (/)
以將錄影帶回轉或前進至起始點。
以將錄影帶回轉或前進至起始點 Joystick () 。
完成回轉或前進後、攝錄放影機會自動停止。
6. 按下 Joystick 以開始播放。
您可以在 LCD 螢幕上檢視您所錄製的畫面。
若要停止播放操作、可向下移動 Joystick () 。
在播放期間調整 LCD Bright / LCD Color。
您可以在播放期間調整 LCD bright/LCD 色彩。
調整方法和在 Camera 模式中使用的程序相同。
➥ 第 31 頁
調整音量
當您使用 LCD 螢幕來播放時、您可以從內置喇叭
聽到所錄製的音效。
- 在攝錄放影機上播放錄影帶時採取以下步驟來
調低音量或設定靜音。
當您聽到錄影帶播放的音效時、使用縮放
( VOL) 桿來調整音量。
- LCD 螢幕上會出現音量顯示。
- 音量可在 "00" 到 "19" 之間進行調整。
- 若您在進行播放時關閉 LCD 螢幕、您將不
會從喇叭聽到音效。
當聲訊 / 視訊纜線連接到攝錄放影機時、您將無法
從內置喇叭聽到音效、同時也不能調整音量。
•
•
•
•
•
•
•
•
•
•
•
•
播放
PLAYING BACK A TAPE ON ThE LCD SCREEN
The playback function and speaker works only in Player mode. ➥page 18
You can monitor the playback picture on the LCD screen.
1. Insert the tape you wish to view. ➥page 34
2. Set the Select switch to TAPE. (SC-D383/D385 only)
3. Press the MODE button to set Player ( ).
4. Open the LCD screen.
Adjust the angle of the LCD screen and set the
brightness or color if necessary.➥page 31
5. Press the Joystick, then move the Joystick (/) left
or right to rewind or forward the tape to the starting point.
To stop rewinding or forwarding, move down the
Joystick ().
The camcorder stops automatically after rewinding or
forwarding is completed.
6. Press the Joystick to start playback.
You can view the picture you recorded on the LCD
screen.
To stop the play operation, move down the Joystick ().
Adjusting the LCD Bright / LCD Color
during Playback
You can adjust the LCD bright/LCD color during
playback.
The adjustment method is the same procedure as
used in Camera mode. ➥page 31
Adjusting the Volume
When you use the LCD screen for playback, you can
hear recorded sound from the built-in speaker.
- Take the following steps to lower the volume or mute
the sound while playing a tape on the camcorder.
When sound is heard once the tape is in play, use
the Zoom(VOL) lever to adjust the volume.
- A volume level display will appear on the LCD screen.
- Levels may be adjusted from anywhere between
"00" to "19".
- If you close the LCD screen while playing, you
will not hear sound from the speaker.
When the Audio/Video cable is connected to the
camcorder, you cannot hear sound from the built-In
speaker and cannot adjust the volume.
•
•
•
•
•
•
•
•
•
•
•
•
playback
AV DV
BATT.
MENU
W
T
MODE
POWER
CHG
MOV_0001 12:00 1.JAN.2008
0:00:30:23
60min
SP
[11]
STOP
MIX[1+2]
16BIt S
AV In
12:00 1.JAN.2008
0:00:30:23
60min
SP
BATT.
CHG
MODE TAPE CARD
(SC-D383/D385 only)