MagTek MICRbase - Manual (Page 35)

Section 5. Options For RS-232 Interface
NETWORK/MODEM OPTIONS
The “Ethernet/Modem Options” box is shown in Figure 5-6 and described below. Each of the
options below has a Source and Fixed value box associated with them. Selecting ‘Fixed’ means
the MICRImage will use the value shown in the Fixed Value box. Selecting ‘DHCP’ means the
MICRImage will take advantage of the dynamic configuration offered by your DHCP server and
obtain the parameter from there. The MICR IP Address must be set to DHCP if any of the other
configuration parameters are going to use DHCP.
DNS 1 IP Address and DNS2 IP Address
These set the IP address for the DNS1 and DNS2 servers.
FTP File Directory
This sets the file directory
MICR IP Address
This sets the IP address for the MICR unit. For example: 192.11.12.127
Subnet Mask
This sets the subnet mask used by the MICR unit. For example: 255.255.255.0
Gateway Address
This sets the IP address for the gateway/router.
FTP IP Address
This sets the IP address for the FTP server. To use DHCP, configure your server to use option
181 for this parameter.
FTP User ID
This sets the user ID used to log onto the FTP server. The maximum number of characters
allowed is 16. To use DHCP, configure your server to use option 179 for this parameter.
FTP Password
This sets the password used to log onto the FTP server. The maximum number of characters
allowed is 16. To use DHCP, configure your server to use option 180 for this parameter.
MODEM OPTIONS
The modem options, shown in Figure 5-6, are used when the MICRImage is configured for
modem use.
27