MagTek MICRbase - Manual (Page 34)

MICRbase, Setup Program for MICR Readers
File Name
This is a template for creating file names in the MICRImage. The following characters may be
embedded in the file name:
* replace with MICR Line
? replace with formatted MICR Line
> replace with file count
< replace with file creation time
: replace with serial #
Auto-Send Image
Checking this box will cause the image to be sent to the image port automatically.
Auto-Save Image
Checking this box will cause the image to be saved in memory automatically.
Snippets
A snippet is a rectangular area in an image. It is specified by enclosing the top, bottom, left, and
right borders of the area in parentheses as follows: (Tn Bn Ln Rn) where n is in pixels measured
from the bottom and right edges of the image if positive, or the top and left edges if negative. If
n contains a decimal point, it means inches. If n contains a comma in place of a decimal point, it
means centimeters. One or two snippets may be specified on each line.
MICR Threshold
Sets the noise threshold for the MICR line. Range: 0-255. Default is 15.
MICR Amp Scale
Sets the amplitude scale factor for the detection of low MICR. Range: 0-255. Default is 128.
OK
Keeps the current options and returns to the first options page, Figure 5-4, “Configure,
MICRImage”.
Cancel
Returns to the first options page, Figure 5-4, “Configure, MICRImage”. Does not retain
configuration changes made to the dialog box.
26