Section 4. operation, Micr reader communication, Communication setup – MagTek MICRbase User Manual

Page 15: Figure 4-1. communication setup

Text mode
Original mode

SECTION 4. OPERATION

This section contains operating selections for communication and configuration of a MICR
Reader.

MICR READER COMMUNICATION

Before configuration, the MICRbase program must establish communication between the PC and
the MICR Reader. The Communicate menu contains dialog boxes that allow the user to
establish and verify communication with the MICR Reader. These dialog boxes are described
below.

Communication Setup

This dialog box is shown in Figure 4-1. The buttons, menus, and check boxes are described
below.

Figure 4-1. Communication Setup

Interface Type – The interface is either RS232 or Wedge. Select one.

Test – This is used to verify the communication between the PC and the MICR. When this
button is clicked, the Status line will respond.