Figure 3-5 fc host ports configuration screen, Figure 3-6 ib host ports configuration screen, 1 host id – APC SGI 15000 RAID User Manual
Page 47: Host wwn, 2 host status
Controller Management
007-5510-002
33
The PORT=X|ALL parameter specifies the specific host port(s) (1 to 4) to be affected when used in
combination with any of the other parameters: ID, TIMEOUT, SPEED (for FC only), or WWN. The
default is to apply changes to ALL host ports.
Figure 3–5
FC Host Ports Configuration Screen
Figure 3–6
IB Host Ports Configuration Screen
3.2.1.1
Host ID
HOST ID=
loop ID is already taken by another device. This parameter is entered as an 8-bit hex value. The default
value is EF.
Host WWN
HOST WWN=X|DEFAULT overrides the system ID and specifies a different World Wide Name (WWN)
for a host port. This parameter is entered as an 64-bit hex value. Default WWN is based on the serial
number of the unit.
3.2.1.2
Host Status
HOST STATUS displays the loop status of each host port (Figure 3–7).