Kenwood R-K1 - Manual (Page 32)

32 EN
ENGLISH
2 Enter the input level adjustment mode
3 Adjust the input level
Adjustment of Input Levels from External Components
1 Perform the procedure in "Basic Operation" till step 2 to select
the [PHONO], [MD], [TAPE] or [AUX] input (see page 14.)
Preparations
÷ Connect the external components in advance as de-
scribed in "Connecting Associated Products (Com-
mercially Available)". (See page 9.)
÷ Switch the external components ON.
The level of the analog signal input from each external compo-
nent can be adjusted independently for the [PHONO], [MD],
[TAPE] and [AUX] input sources. Adjust the input levels so that
the audio from the external components are played at a similar
volume to CD playback.
I - n p u t L e v e l 6
÷ The level can be adjusted in three steps of -6, -3 and 0. (Begin
the level adjustment within 20 seconds.)
÷ When the input level is adjusted so that the audio from the se-
lected external component is played at a similar volume to CD
playback, the level of recording the signal from the input con-
nector is also adjusted to a similar level regardless of the input
source component. Therefore, do not vary the input level in the
middle of recording as this will vary the recording level.
Switching the displayed information
Each press switches the selection.
1 Input selection display
2 Day of the week and time of day display
MUTE MODE
AUTO/MONO DIRECT
TUNER CD D.AUDIO
MD PHONO TAPE
AUX D-IN 1 D-IN 2 DIMMER
TIMER
SLEEP
TIME/PTY
CLEAR DISPLAY
P.MODE RANDOM REPEAT OPEN/ CLOSE
FOLDER BASS TREBLE
BALANCE
PREV. NEXT
: Keys and controls used in the operation.
1 Press the MODE key
2 Select [Input Level]
\
Advance
Return
Enter the
selection.
\
Increase
Decrease
Enter the
selection
I n p u t L e v e l 0
I n p u t L e v e l
«
÷ The input level display starts to blink. (Begin the level adjust-
ment within 20 seconds after the display appears.)