Kenwood R-K1 - Manual (Page 20)

20 EN
ENGLISH
MUTE MODE
AUTO/MONO DIRECT
TUNER CD D.AUDIO
MD PHONO TAPE
AUX D-IN 1 D-IN 2 DIMMER
TIMER
SLEEP
TIME/PTY
CLEAR DISPLAY
P.MODE RANDOM REPEAT OPEN/ CLOSE
FOLDER BASS TREBLE
BALANCE
PREV. NEXT
1 Connect a digital audio player
Playback of Digital Audio Player
3 Start playback
When a Kenwood digital audio player is connected to the system
using the dedicated cable, the player can be controlled from this
system or the remote control unit.
Both the system and digital audio player should be
switched OFF before connecting them.
÷ Using the dedicated cable, connect the [D.AUDIO IN] connec-
tor on the rear panel of the system and the headphones jack of
the digital audio player.
÷ After playing the digital audio player, be sure to disconnect the
connection cable.
÷ A commercially available stereo mini-plug cable can be used
for the connection. In this case, however, the input from the
digital audio player can be output from the system but the
player cannot be controlled from this system or the remote
control unit.
Dedicated cable
To headphones jack
÷ Simply pressing the D.AUDIO 6 key on the remote control
unit selects the [D.AUDIO] input source and starts playback.
Controlling the digital audio player
: Keys and controls used in the operation.
1 Select the [D.AUDIO] input
2 Press 6/BAND key
To let it playback or pause temporarily
÷ Each press of the key switches the pause and play modes alter-
nately.
2 Switch the system and digital audio player ON