Kenwood R-K1 - Manual (Page 14)

14 EN
ENGLISH
4 Adjust the volume
3 Play the selected input source
Basic Operation
1 Switch the system ON
Turning the knob switches the input functions in the follow-
ing sequence.
1 [TUNER]
2 [CD]
3 [D.AUDIO]
4 [PHONO]
5 [MD]
6 [TAPE]
7 [AUX]
8 [D-IN1 (OPT)]*
9 [D-IN2 (COAX)]*
D - I N 1 4 8 k H z
Sampling frequency of the input signal
* The digital signal that can be reproduced with this system is
only the PCM (32 kHz to 96 kHz) signal.
÷ "CD Playback" (See page 17.)
÷ "Radio Reception" (See page 23.)
2 Select the input source
Each press of the power key switches the system mode alter-
nately.
1 Standby indicator ON: The system power is OFF (standby
mode).
2 Standby indicator OFF: The system power is ON.
÷ The system is also switched ON and playback (tuner reception)
can be started when the TUNER/BAND, CD 6, D.AUDIO 6
or an input selector (PHONO, MD, TAPE, AUX, D-IN 1, D-IN 2)
key on the remote control unit is pressed.
V o l u m e - 3 0 . 0 d B
Volume display
÷ When the volume level is -30dB or higher, it can be adjusted
more finely in 0.5 (dB) steps.
MUTE MODE
AUTO/MONO DIRECT
TUNER CD D.AUDIO
MD PHONO TAPE
AUX D-IN 1 D-IN 2 DIMMER
TIMER
SLEEP
TIME/PTY
CLEAR DISPLAY
P.MODE RANDOM REPEAT OPEN/ CLOSE
FOLDER BASS TREBLE
BALANCE
PREV. NEXT
: Keys and controls used in the operation.
MD PHONO TAPE
AUX D-IN 1
TUNER
BAND
CD
6
D.AUDIO
6
D-IN 2
To decrease
volume
To increase
volume
To increase
volume
To decrease
volume