High Country Tek emc-3 - Manual (Page 34)

Page 34 of 39
emc-3 Controller Module
User Guide – Rev A
5) DVC Family Master Display:
The Program Loader Monitor is
used to observe the actual input
and show specific information as
your application executes.
The names assigned to them in
the Programming Tool appear on
the main screen shown below. The
runtime graph is used to plot any
two variables as fast as the
computer can collect data from the
DVC.
To allow the next step, and load the application, the user MUST click the
‘Program Loader’ button shown here:
6) Program Loader
Once clicked the Program Loader button sets a signal in the serial cable that
allows the DVC to go into programming mode when power is cycled.
After selecting the Program Loader button in 5) above, and power cycling the
DVC, look for the indicator in the Program Loader window to change color and
determine that the DVC controller is in programming mode:
The Load Application Button will go from
Unavailable ( left ) to Available ( below ) the
module is now ready to accept a new program.
To load your new application, Click in the Path
Window to select an application file then select the
Load Application
button shown here.