beautypg.com

Red Lion CUB7 User Manual

Description, Safety summary, Dimensions in inches (mm)

background image

1

2.00 (50.8)

1.10 (27.9)

0.11 (2.8)

0.10 (2.5)

1.56 (39.6)

0.87 (22.0)

0.874

1.77

(22.2 )

(45 )

+0.024

-0.000

+0.6

-0.0

+0.012

-0.000

+0.3

-0.0

85374216

LCD, POSITIVE IMAGE REFLECTIVE OR NEGATIVE IMAGE

TRANSMISSIVE WITH YELLOW/GREEN OR RED LED
BACKLIGHTING (9-28 VDC power supply required for versions with
LED backlighting)

AVAILABLE WITH LOW SPEED CONTACT (30 Hz MAX.), HIGH

SPEED LOGIC (10 KHz MAX.)

PRESCALER FROM 0.0001 TO 1.9999

SELECTABLE DECIMAL POINTS

REPLACEABLE INTERNAL LITHIUM BATTERY PROVIDES UP

TO 6 YEARS OF UNINTERRUPTED OPERATION (Battery Included)

WIRE CONNECTIONS VIA SCREW CLAMP TYPE TERMINALS

FRONT PANEL AND REMOTE RESET INPUT

NEMA 4X/IP65 SEALED FRONT BEZEL

BOTH FRONT PANEL PROGRAM AND RESET BUTTONS ARE

INDIVIDUALLY ENABLED

DESCRIPTION

The CUB7P is an 8-digit miniature programmable counter with large 0.35

inch (8.90 mm) high digits. It has an LCD read-out available in Positive Image
Reflective, Negative Image Transmissive with yellow/green backlighting, or red
backlighting. Backlight units require an external 9 to 28 VDC power supply.

The CUB7P is available in either Low Speed Contact or High Speed Logic.

The Contact versions (CUB7P0xxx) operate from a switch contact or an NPN
open collector transistor. The Logic versions (CUB7P2xx) operate from 3 VDC
logic output or from an NPN open collector transistor.

The CUB7P has a programmable prescaler that can be set for any value

between 0.0001 and 1.9999. The decimal point position can be set anywhere
from 0 (no D.P.) to 0.000000 or no Leading Zero Blanking. Both the prescaler
and DP selection are accessed using the front panel PGM and RESET push
buttons. See Programming for details. Note that the count, prescaler and DP
values will be lost if the battery is removed. See BATTERY INSTALLATION
for additional information.

The CUB7P counters use a CMOS LSI chip, mounted on a gold-plated

substrate, that is electrically connected by ultrasonic wire-bonding. Proven
micro-electronic assembly and manufacturing techniques provide these units
with the reliability and dependability required for industrial service.

The CUB7P series is housed in a lightweight, high impact plastic case with a

clear viewing window. The sealed front panel with the silicone rubber buttons
meets NEMA 4X/IP65 specifications for wash-down and/or dusty environments,
when properly installed.

SAFETY SUMMARY

All safety related regulations, local codes and instructions that appear in the

manual or on equipment must be observed to ensure personal safety and to
prevent damage to either the instrument or equipment connected to it. If
equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.

Do not use this unit to directly command motors, valves, or other actuators

not equipped with safeguards. To do so, can be potentially harmful to persons
or equipment in the event of a fault to the unit.

MODEL CUB7P PROGRAMMABLE ELECTRONIC 8-DIGIT COUNTER

DIMENSIONS In inches (mm)

Note: Recommended minimum clearance (behind the panel) for mounting clip installation

is 2.15" (54.6) H x 3.00" (76.2) W.

PANEL CUT-OUT

Bulletin No. CUB7P-C
Drawing No. LP0647
Released 05/09

Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net

CAUTION: Risk of Danger.

Read complete instructions prior to

installation and operation of the unit.

BNL10000

CUB7P220

CUB7P210

CUB7P200

CUB7P020

CUB7P010

CUB7P000

PART NUMBER

Counter; Positive Image Reflective

Counter, w/Yel-Grn Backlighting

Counter; w/Red Backlighting

Counter; Positive Image Reflective

Counter, w/Yel-Grn Backlighting

Counter; w/Red Backlighting

Replacement 3 V Lithium Battery

BNL

HIGH SPEED

LOGIC INPUT

*CUB7P

LOW SPEED

CONTACT INPUT

MODEL NO. DESCRIPTION

* Battery is included with unit.

ORDERING INFORMATION