Vaisala WMT700 - Manual (Page 67)

Chapter 5 ______________________________ Operating WMT700 with WS425 and SDI-12 profiles
VAISALA _______________________________________________________________________ 65
aAb! — Change Address
This command changes the WMT700 address. After WMT700 has
received this command and sent a response, the sensor does not respond
to any other command for one second. This gives WMT700 time to write
the new address to the non-volatile memory.
NOTE You can also change the WMT700 address by entering configuration
mode and changing the address parameter.
aAb!
where
a =
The current single-digit WMT700 address that
corresponds to the first character of the address value.
A = The change address command.
b = The new address.
! = Terminates the command.
The response is the following:
b
where
b
= The new single-digit WMT700 address (or the original
address if WMT700 is unable to change the address).
= Terminates the response.
aC! — Start Concurrent Measurement
This command starts concurrent measurement. WMT700 does not return
measurement data after this command. It sends a response that indicates
when the measurement result can be retrieved using the aD0! command
and the number of parameters.
aC!
where
a
= The single-digit WMT700 address that corresponds to
the first character of the address value.
C = The start concurrent measurement command.
! = Terminates the command.