Vaisala WMT700 - Manual (Page 43)

Chapter 5 ______________________________ Operating WMT700 with WS425 and SDI-12 profiles
VAISALA _______________________________________________________________________ 41
CHAPTER 5
OPERATING WMT700 WITH WS425
AND SDI-12 PROFILES
This chapter provides information for operating WMT700 in serial
operation mode with WS425 or SDI-12 profiles.
In this chapter each communication profile has its own section listing the
configurable parameters and the available commands and data messages.
For information on available commands and data messages when using
the WMT700 profile, see Vaisala WINDCAP® Ultrasonic Wind Sensor
Series WMT700 User's Guide.
NOTE For a complete list of the serial commands available for WMT700, refer
to Appendix A, Complete Command Set for WMT700, on page 75.
Communication Profiles
In addition to the WMT700 and MES12 profiles, WMT700 supports the
following communication profiles:
- WMT700
- ROSA - MES12
- WS425 - ASCII
- WS425 - NMEA Extended (version 0183)
- WS425 - SDI-12 (version 1.3)
- WS425 - ASOS
The profile has been preconfigured at the factory according to the
requirements specified when ordering WMT700. You can change the
profile through the serial interface, if necessary. For instructions, see
Vaisala WINDCAP
® Ultrasonic Wind Sensor Series WMT700 User's
Guide.