Vaisala WMT700 - Manual (Page 24)

TECHNICAL REFERENCE___________________________________________________________
22 __________________________________________________________________ M211097EN-C
Table 3 Mounting Kits and Cable Codes
FIX70 FIX30 FIX60
Description Spare Part Item
In Out In Out In Out
227567SP x x x x x
227568SP x x x x x
231425SP x x x x x
228259SP x x x x x
WMT700 Cables with open
leads one end
(Standard 2m/10m, RS485
2m/10m, ROSA analog 10m)
228260SP x x x x x
227565SP x x x x x x
229807SP x x x x x
WMT700 Cables with
connectors on both ends
(MAWS, AWS520):
227566SP x x x x x
Mounting Procedure
To upgrade from WS425 to WMT700:
1. Uninstall the WS425 wind sensor.
2. If you are using a WMT700 cable, run the cable through the
WS425 mounting kit. Connect the cable to the WMT700 wind
sensor.
If you are using a WS425 cable, ensure the pre-installed o-ring seal
sits properly in the plastic male connector (between the existing
WS425 cable and the adapter cable). Connect the WS425 cable to
the WS425 adapter cable (see Figure 8 below). Run the adapter
cable through the WS425 mounting kit. Connect the cable to the
WMT700 wind sensor.
1103-012
Figure 8 WS425 Adapter Cable
3. Tighten the connector by rotating the connector by hand clockwise,
see Figure 9 on page 23.
Ensure that the connector is properly tightened before proceeding
to the next step. If you are unable to tighten the connector, loosen
the mounting adapter fixing screws, remove the mounting adapter,
and connect the cable. After that, reattach the mounting adapter.