Vaisala DPT146 - Manual (Page 52)

User's Guide _______________________________________________________________________
50 ___________________________________________________________________ M211372EN-D
Closing the Connection to a Transmitter
in POLL Mode
The CLOSE command closes the connection to a transmitter.
CLOSE
Example:
close
line closed
Show Transmitter Uptime
Use the TIME command to show how long the transmitter has been
operating since it was last reset or powered up.
TIME
Example:
time
Time : 03:14:10
Reset Transmitter
Use the RESET command to reset the transmitter.
RESET
When the RESET command is given, the transmitter will restart as if it
had just been powered on. All transmitter settings are retained. The serial
line mode of the transmitter will be set to the mode that was set using the
SMODE command.
Restore Factory Settings
Use the FRESTORE command to restore the factory settings to the
transmitter. All user settings will be lost.
FRESTORE