Figure 9, Installing the transmitter, Figure 10 – Vaisala DPT146 User Manual
Page 25: Tightening with a wrench, Caution
Chapter 4 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 23
1109-032
Figure 9
Installing the Transmitter
1109-033
Figure 10
Tightening with a Wrench
3.
Tighten the connection by turning with a wrench (max. 50 Nm).
CAUTION
Only tighten the transmitter from the 30 mm nut. Do NOT apply force to
other points in the transmitter body.
4.
Continue with the wiring of the transmitter. See section Wiring on
page 24.
See also other documents in the category Vaisala Tools:
- DM500 (138 pages)
- DM70 (93 pages)
- DMT132 (74 pages)
- DMT143 (76 pages)
- DMT152 (70 pages)
- DMT242 (4 pages)
- DMT340 (191 pages)
- DMT345 (185 pages)
- DPT145 (63 pages)
- PTU300 (217 pages)
- PTB330TS (89 pages)
- PTB220 (10 pages)
- PTB220 (113 pages)
- PTB330 (144 pages)
- PTU200 (64 pages)
- PTU200MIK1 (18 pages)
- SPH10 (2 pages)
- SPH20 (2 pages)
- PTB110 (4 pages)
- PTB200 (30 pages)
- PTB210 (analog) (27 pages)
- PTB210 (serial) (32 pages)
- GM70 (68 pages)
- GMD20 (4 pages)
- GMK220 (18 pages)
- GML20 (2 pages)
- GML20T (2 pages)
- GMM20W (5 pages)
- GMM220 (6 pages)
- GMP231 (2 pages)
- GMP231 (90 pages)
- GMP343 (94 pages)
- GMR20 (2 pages)
- GMT220 (42 pages)
- GMW90 (101 pages)
- XMW90 (4 pages)
- MM70 (67 pages)
- MM70 (71 pages)
- MMT162 (66 pages)
- MMT310 (81 pages)
- MMT330 (181 pages)
- MMT330 (171 pages)