Vaisala DM500 - Manual (Page 88)

User's Guide ______________________________________________________________________
86 __________________________________________________________________ M210205EN-D
Setting commands
SERI
Setting the serial communication parameters
UNIT Setting the units
TIME Setting the date and time
RSEL Setting the relays
ASEL Setting and scaling the analog outputs
AERR Setting the invalid output value for the analog channel
COOLER* Setting the cooling method status
FLOW* Setting the flow value
XFLOW* Setting the flow value temporarily
PRES*
Setting the pressure
XPRES*
Setting the pressure value temporarily
TP*
Setting the temperature
XTP* Setting the temperature value temporarily
Adjustment commands
CDP*
Adjusting the dewpoint temperature (in 4...10 points)
CTP* Adjusting the temperature (in 2 points)
FCAL* Adjusting the flow meter (in 1 point)
PCAL* Adjusting the pressure sensor (in 2 points)
Others
?
Outputting the device settings
?? Outputting the device settings in POLL-state
DEL Deleting the data files
DIR Outputting list of data files
ECHO Setting the echo ON/OFF
ERRS Outputting the error messages
HELP Outputting the commands
INIE* Returning the factory settings
SMODE Selecting the operation mode
OPEN Opening the line in poll mode
CLOSE
Closing the line in poll mode
PLAY
Outputting the data file or history memory
SCC*
Sensor circuit check
SSC* Sensor status check
SNUM* Outputting the serial numbers of DM500
VERS* Outputting the program name and version
*when serial cable is connected to the DMP501 service port, only the commands marked with * can be used.
Command syntax and output may be different in direct connection to DMP501 sensing unit.
Output Commands (DMI500)
R Continuous Output
Syntax: R
Outputting measured values continuously. You can modify the form
of the output with the command FORM (see page 88). The resulting
interval can be set with the command INTV (see page 87). The