Pole installation, Figure 15, Hms82/83 pole installation – Vaisala HMDW80 User Manual
Page 26: Figure 16, Securing the cable on a pole
User's Guide _______________________________________________________________________
24 ___________________________________________________________________ M211510EN-C
Pole installation
NOTE
Recommended pole diameter for HMS82/83 installation with the
supplied clamp and screws is 25 ... 60 mm.
1.
Use the supplied clamp and screws to mount the transmitter on a
pole.
2.
To prevent the transmitter from turning on the pole, tighten the set
screw on the center hole of the clamp.
1304-054
Figure 15
HMS82/83 Pole Installation
3.
Plug in the screw terminal block, close the cover, and tighten the
screws.
4.
Secure the cable to the pole using a zip tie. Allow some cable to
hang down from the cable gland to prevent water from entering the
transmitter along the cable.
1304-056
Figure 16
Securing the Cable on a Pole