DAVIS Wireless Temp/Hum Station, 2003 & newer - Manual (Page 3)

Preparing the Temp/Hum Station 3
5. Fasten the mounting bracket in place using the three long screws as shown
in the illustration below.
Applying Power
1. Turn the main part of the ISS upside down. This is the part that includes the
rain collector and the radiation shield.
2. Push back on the two plastic latches to release the cover, then open the cover.
You should now be able to see the sensor interface module (SIM).
Re-install
Mounting
Bracket
Radiation
Shield
Assembly
Lock Washers
Flat Washers
4" Bolts
Optional Screw Fastening Holes.
Use self-threading screws:
#6 x 0.5" (3.5mm x 12 mm)
SIM Housing
SIM Housing Cover
Use your thumbs to push
back on the two (2) plastic
latches. 1
With the latches pushed
back, use your fingers to
lift up on the corner edges
of the cover.
2
Opening the SIM Housing Cover