DAVIS Wireless Temp/Hum Station, 2003 & newer - Manual (Page 2)

2 Installation Steps
Installation Steps
For ease of installation, please follow the steps in the order presented.
• Preparing the Temp/Hum Station, page 2
• Rotating the Mounting Bracket, page 2
• Applying Power, page 3
• Setting the Transmitter ID, page 4
• Setting Console Station ID on the Console, page 5
• Setting the Console Station ID using WeatherLink, page 6
• Viewing Current Temperature and Humidity, page 6
• No Communication with Temp/Hum Station?, page 6
• Choosing a Location for the Temp/Hum Station, page 7
• Testing Transmission from Proposed Location, page 7
• Mounting the Temp/Hum Station, page 8
• A Note on Securing Cables, page 11
See “Maintenance” on page 10. For Technical Support, see “Contacting Davis
Instruments” on page 11.
Preparing the Temp/Hum Station
Rotating the Mounting Bracket
To facilitate packing and
shipping the Temp/Hum
Station, the mounting bracket
is installed upside down at
the factory. You will need to
rotate the mounting bracket
180° before you install the
station.
1. Place the Temp/Hum
Station on a level surface.
2. Loosen the three mount-
ing screws that hold the
mounting bracket and the
radiation shield together.
3. When the screws are com-
pletely loosened, lift the
mounting bracket away
from the radiation shield.
4. Rotate the mounting bracket and replace it on the radiation shield.
Radiation
Shield
Assembly
Remove
and
Rotate
Mounting
Bracket
Remove
Mounting
Screws