Telenav for Nextel Supported Devices: v2.2.5 for Motorola i830 - Manual (Page 33)

© TELENAV 2003-5 PAGE 33 OF 39
Using a Waypoint as an address
If you choose to use a Waypoint as an address, you will be presented with a list of waypoints you have
previously marked and labeled as shown above under View Waypoints. Highlight the one you want,
and press OK. At this point, your phone will contact the TeleNav servers to convert the latitude and
longitude of the waypoint to an approximate street address.
Guidance Instructions
The guidance instruction screens you will see have the following content, but will have different
proportions than those shown below. GPS navigation and Non-GPS directions screens have slightly
different content explained below. When TeleNav is communicating with the TeleNav servers, a
network activity indicator replaces the GPS indicator shown below.
Lawrence Expwy
CA CR-9N
3.4 mi
US 101 N
6.2 mi NW
Direction of
travel
GPS
satellite
indicator
Remaining
distance
Distance to
next turn
Current
street
name
Upcoming
turn type
icon
Upcoming
street
name and
alternate
name
Navigation guidance
If you will be traveling on the same roadway for a mile or more, the Upcoming and Current Street
names will be the name of the street you are on, and the turn type icon will be a vertical arrow. As you
approach the turn, the Upcoming Street name will change, and the icon will portray the actual type of
turn you should make. As you move, the distance to turn and the remaining distance will decrease.
The way this operates can be changed as described below under Personalization.
Eventually, you will see the destination arrival screen. This screen will show you how far it is to your
destination and whether it is on the left or right side of the street or road.
For TeleNav to work, the GPS receiver must be tracking four or more satellites. When 3 or less are
being tracked, the satellite indicator will be blank. When four satellites are being tracked, one bar will
appear. As more satellites are tracked, more bars appear. If the indicator is blank, you should more to
an area with a clearer view of the sky.
When you arrive at your destination, press BACK. This will take you back to the TeleNav submenu.