DiabloSport Extreme PowerPuck - Manual (Page 28)

13
INSTALLATION
w w w .
D I A B L O S P O R T
. C O M
9. To prevent damage to the valve seal surface, place the
valve into the vice with a thick piece of cardboard
or wood facing the valve cap.
10. Using your small punch and hammer, carefully re-apply
the 3 factory indentations to the valve lip. These indentations
should be applied to the lip where
the valve casing covers the valve
cap. In order to rotate the valve
you may need to loosen the vice.
When doing this be sure not to
allow the spring to push the cap
out. After punching the three
indentations, remove the valve
and make sure the valve cap is held in place by your new
indentations. if not, repeat step 9 & 10.
2007.5+ Dod
ge 6.7L