Boonton PIM 31 User Manual - Manual (Page 70)

70
9.2 Using PIM31 Remote Application:
Before using the remote application the following default settings for both
IP address and port number need to be verified.
9.2.1 Enter IP address and Port
• Open the “PIM31 Remote Control” software from desktop
• Verify that the IP Address is same as PIM31:
Default : 192.168.0.10
• Enter Port
3100
• Press”Connect” button.
The “Equipment Get” buttons is now enabled
• With proper connection PIM31 should now show “Remote Control” on
its screen
• Press “Equipment Get” button.
The model is now shown in the Equipment field and the settings of
equipment are shown as well.
• Change settings by overwriting the relevant fields and push “Set” button.
• Pressing “RF ON” activates the RF and measurements are done
automatically.
• “RSSI” can be pushed while RF is off