Boonton PIM 31 User Manual - Manual (Page 101)

101
The system will boot up automatically and show the user interface in Analyzer
Mode, as shown below:
(2) Before Making Measurements:
Before starting to measure components with the PIM31-F07-UL system, users
are urged to familiarize themselves with the precautions & safety procedures.
Improper operation and handling can cause bodily harm, or damage the
instrument.
• Attach a connector saver to both the RF Port and to the Load (if not
already attached).
Preparations:
• Connect the Low PIM cable to the Test system (Note: always connect the
test cable to the instrument prior to connecting to the DUT).
• Connect the Load to the test system.