Boonton 4530 Peak Power Meter User Manual - Manual (Page 119)

4-45
Boonton Electronics Chapter 4
4530 Series RF Power Meter Remote Operation
OUTPut:EXTernal:MODulation
Description: Set or return the output modulation state for the 2530 external calibrator. If set to CW, a
calibrated CW signal will be generated. If set to PULSE, the output will be pulse modulated
as specified by the
OUTPut:EXTernal:PULse:PERiod , :DCYC , and :SOURce settings.
Syntax: OUTPut:EXTernal:MODulation
Argument: = CW, PULSE
Valid Modes: Any
OUTPut:EXTernal:PULse:PERiod
Description: Set or return the pulse period for the 2530 external calibrator’s internal pulse modulator.
Syntax: OUTPut:EXTernal:PULse:PERiod
Argument: = 0.1, 1, 10 milliseconds
Valid Modes: Any
OUTPut:EXTernal:PULse:DCYC
Description: Set or return the pulse duty cycle for the 2530 external calibrator’s internal pulse modulator.
Syntax: OUTPut:EXTernal:PULse:DCYC
Argument: = 10, 20, 30, 40, 50, 60, 70, 80, 90 %
Valid Modes: Any
OUTPut:EXTernal:PULse:SOURce
Description: Set or return the pulse modulation source for the 2530 external calibrator. If set to INT, the
internal pulse generator is used. EXT selects the signal from the calibrator’s rear-panel “Ext
Pulse” input. Note this input is 50 ohms, and requires TTL compatible signal levels.
Syntax: OUTPut:EXTernal:PULse:SOURce
Argument: = INT, EXT
Valid Modes: Any
OUTPut:RECOrder:SIGNal
Description: Set or return the on/off state of the instrument’s rear-panel Recorder Output port.
Syntax: OUTPut:RECOrder:SIGNal
Argument: = OFF, ON
Valid Modes: Any
OUTPut:RECOrder:SOURce
Description: Set or return the source channel for the recorder output.
Syntax: OUTPut:RECOrder:SOURce
Argument: = CH1, CH2
Valid Modes: Any