3 alarm system – AirSep MN179-1 B User Manual
Page 14

MN179-1 _ 02/14 AirSep Corp. - FreeStyle 5 Service Manual Rev B
2.3 Alarm System
An audible alarm sounds if FreeStyle 5 has a low battery, senses no
inspiration, high temperature ,system overdraw, high or low pressure. If an
alarm sounds, observe which lights are on. The visual and audible alarm
conditions are explained in detail below.
2.3.1 Start-Up
A one-second, audible alarm sounds to indicate start-up. FreeStyle 5 begins
to operate when the alarm stops.
2.3.2
Battery Status
To check the level of charge of the internal battery, press the BATT button on
FreeStyle 5’s keypad. The battery gauge / indicator(s) LEDs above the BATT
button illuminate from 25-100% to indicate the level (capacity) of the internal
battery. At less than 25% capacity, the 25% LED blinks.
2.3.3 Low Battery
As the battery power approaches a low level, a ½ second beep is emitted every
five seconds, and a yellow LED on the battery gauge / indicator(s) will blink
for a ½-second every five seconds. When this occurs, the patient is instructed
to connect the FreeStyle 5 AC or DC power supply or change to another
source of oxygen. The low battery alarm will continue for approximately 2
minutes before FreeStyle 5 stops operating.
2.3.4 Discharged Battery
When the battery is discharged, the unit shuts down. Before this occurs, a ½
second beep sounds every ½ second and the yellow battery LED blinks at the
same rate until any one of the 1-5 settings on the keypad are pressed. After the
alarm is turned off, connect the FreeStyle 5 unit to its AC or DC power supply
or change to another source of oxygen immediately. When the FreeStyle 5
unit is connected to the AC or DC power supply, FreeStyle 5 operates and
the internal battery recharges simultaneously.